Braun Clean and Renew Electric Shaver Cleaning Cartridges, Hygienically Cleans, Removing Residual Hair & Skin Particles, 5+1 Pack, Lemon Fresh

Product Information

I also noticed that when shaving, with the razor in constant contact with the skin, the foils heat up a little less than when idling. I have a Series 8 and the sensor is definitely looking for the conductivity so the baking soda is essential.

It would also be rather difficult for a small manufacturer to come up with a different design and they usually just replicate/reverse engineer the original ones.Just make sure to shake off most of the water, maybe even pat the shaver/cassette with a clean towel or paper tissue. Pour into a wide container Philips Jet Clean solution or Sterilium in an amount that will cover the shaving head. I do not know the alcohol concentration as it’s not mentioned on the bottle, but I suspect it’s pretty high. By the way, the stickiness mentioned above could be mistaken for moisture, but it wasn’t the case as the blades and foils were perfectly dry. I also don’t really care about the distant prospect of paint peeling, again, this is an issue with the OEM solution as well.

I have been using straight isopropyl alcohol in a plastic bowl to clean my razor with every charge for years – probably since 2011. When I get Cleanerist and Shaver Shebang, I will definitely compare their effectiveness with the original solution, but I already have good expectations.

About cleaning: after shaving I release the catridge and flush it (and the machine’s socket) under warm water.

Looking forward to seeing the results of the silicone oil, that’s definitely uncharted territory for me. That is correct, the paint chipping on the Series 7 is a well-known problem, acknowledged by Braun, but never fixed or addressed in any manner. In my opinion this is not really acceptable and the cleaning solution should provide enough lubrication. But even so, the shaving head appeared to be properly cleaned and the fluid was still effective at removing grime. Clean station works, but after dry process complet and shaver is full out of station shaver is not dry it have liquid inside of head, and no matter if i pull it out of station next day.Moreover, with DIY solutions, the lubricating properties of the mix are almost impossible to get right. According to Braun’s data sheet, they use either ethanol or isopropyl with a concentration between 60% and 100% (they do not state the exact concentration). We have a fantastic range of quality products available at our main site, including domestic spares, shaver spares, health care products and much more! Even if you use the station daily that’s still 24 hours in which some of the alcohol-based fluid will naturally evaporate.